1、SUZHOU JICHEN INDUSTRY CO.,LTD Electric Mosquito Repellent Mat Paper 2、CAN SUPPLY ACCORDING TO CUSTOMER’S NEED Printing mat: one-side print label and pattern and double-side print label and pattern. Carve word mat; one-side carvel label and pattern. Anti-counterfeit mat, the marker can on the print pattern and label. Press frame mat or hole mat (one hole, double hole or triple hole) Special mat according to the customer. 3、MAIN FUCTION TARGET： LENGTH:35±0.15mm WIDTH:22±0.15mm THICKNESS:2.3—2.8±0.15mm（can be according to customer’s special request） DENSITY:0.4±0.05g/cm3 MOISTURE:<8% DIFFUSE VELOCITY:<24h WATER ABSORPTION:<6s（seconds） WHITENESS:70% APPREARANCE:Surface and surrounding is smooth, no burr, no layer and no smudge. Thickness and Density is even and consistent. PACKING REQUIREMENT: The packing of paper mat includes paper box, plastic bag, and paper carton. No small waste paper in the paper box. The outside of the paper carton should note the product name, quantity, merchandiser’s name, production date, product serial number and the punching machine number. 4、CHARACTERISTICS COMPARED WITH SAME PRODUCTS: 1.Without any additive, can fully ensure the active ingredient in the impregnate mixture. 2.The content of water in the mat is low. It’s hard and there’s small change in the size when it absorb moisture and is processed. 3.The arrangement of fiber in the mat is good, so the surface and surrounding is smooth. Can ensure the enough match of mat and reach the best mosquito repellent effect. 4.The mat’s stoma rate, diffusivity and venting quality are higher than of manual mat and the diffusivity and the constancy of release of the mosquito repellent impregnate mixture are all better than the manual mat. 5.The oil absorption of the mat is good. Ensure good volatilize of the drug mixture, and the minimum remains. 6.The density of mat is good, no layer; ensure the 10 hours mosquito repellent effect. 7.Thickness and the overall quality are stable. It’s good for machine filling pack and it can greatly decrease the waste situation and the mat block caused by thickness difference in the filling pack process so as to increase the finished product rate and efficiency. Lower the manufacturing cost.